# Safety and regulatory guidelines

Source: [https://docs.qualcomm.com/doc/80-60631-1/topic/Safety-and-regulatory-guidelines.html](https://docs.qualcomm.com/doc/80-60631-1/topic/Safety-and-regulatory-guidelines.html)

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

- This device may not cause harmful interference.
- This device must accept any interference received, including interference that may cause an undesired operation.

The QTS110 has been tested to the limits for a Class B digital device, according to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.

The QTS110 generates, uses, and radiates radio frequency energy. If the QTS110 is not installed and used according to instructions, it may cause harmful interference to radio communications or be interfered with. There is no guarantee that interference will not occur in a particular installation.

- If QTS110 causes harmful interference to radio or television reception, which can be determined by turning the QTS110 OFF and ON, try to correct the interference by taking one or more of the following actions:
    - Increase the distance between the QTS110 and radio or television receiver
    - Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
    - Consult the dealer where you bought your radio/TV or an experienced radio/TV technician
- If QTS110 is being interfered with, try to correct the interference by taking one or more of the following actions:
    - Ensure that the outlet where the QTS110 is plugged into is no closer than 10 ft (3 m) of a Wi-Fi access point, microwave oven, or 2.4 GHz cordless phone.
    - Increase the distance between the QTS110 and all other electronic equipment by moving the device to a different electrical wall outlet.
- Do not install the device in locations that may expose the product to ignitable or flammable gases or liquids.
- Do not expose the 2net™ device to extreme temperatures.
- Plug the AC adapter only into a power source in accordance with the input voltage ratings marked on the AC adapter.
- Do not operate the device with a damaged plug, or after the product malfunctions or is dropped or damaged in any manner. Avoid dropping the device.
- Do not clean the tracker with any solvent and avoid immersing/dipping it in water.
- Do not dispose of the tracker in household waste; use USB cables that are compliant and do not crack open the tracker casing.

## Battery warnings

Changes or modifications not expressly approved by the party responsible for compliance
        could void the user’s authority to operate the equipment.

**English - CAUTION**

- Risk of explosion if the battery is replaced by an incorrect type.
- Disposal of a battery into fire or a hot oven, or mechanically crushing or cutting of
            a battery that can result in an explosion.
- Leaving a battery in an extremely high temperature surrounding environment can result
            in an explosion or the leakage of flammable liquid or gas.
- A battery subjected to extremely low air pressure that may result in an explosion or
            the leakage of flammable liquid or gas.
- When using class I AC adapter must be earthed. The power plug must be connected to a
            properly wired earth ground socket outlet. Hazardous voltage could occur on user
            accessible metal parts by improperly wiring socket outlet.
- This product is intended to be supplied by a UL listed power adapter rated output
            5 Vdc, min. 1.5 A, Tma is 60ºC minimum, altitude is 2000 m minimum.

**Français - MISE EN GARDE**
- Pile au lithium Attention: Risque d'explosion si la pile n'est pas remplacée
            correctement. Remplacez uniquement par un type identique ou équivalent. Jetez les piles
            conformément aux instructions du fabricant.
- Mise au rebut d'une BATTERIE dans un feu ou un four chaud, ou écrasement ou
            découpage mécanique d'une BATTERIE, pouvant entraîner une EXPLOSION
- Laisser une BATTERIE dans un environnement extrêmement chaud pouvant entraîner une
            EXPLOSION ou une fuite de liquide ou de gaz inflammable
- UNE BATTERIE soumise à une pression d'air extrêmement basse pouvant entraîner une
            EXPLOSION ou une fuite de liquide ou de gaz inflammable.
- Lors de l'utilisation de l'adaptateur secteur de classe I, il doit être mis à
            la terre. La fiche d'alimentation doit être connectée à une prise de terre
            correctement câblée. Une tension dangereuse peut se produire sur les pièces métalliques
            accessibles à l'utilisateur en cas de câblage incorrect de la prise de courant.
- Ce produit est destiné à être alimenté par un adaptateur d'alimentation homologué
            UL sortie nominale 5 Vdc, min. 1,5 A, Tma est de 60 degrés C minimum, l'altitude est
            de 2000 m minimum.

## ISED compliance statement

**English**

This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation,
        Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the
        following two conditions:
- This device may not cause interference.
- This device must accept any interference, including interference that may cause
            undesired operation of the device.

**Français**

L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux
        CNR d’Innovation, Sciences et Développement économique Canada applicables aux appareils
        radio exempts de licence. L’exploitation est autorisée aux deux conditions suivantes:
- L’appareil ne doit pas produire de brouillage.
- L’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage
            est susceptible d’en compromettre le fonctionnement.

## Radiation exposure statement

**English**

This equipment complies with FCC/IC RSS-102 radiation exposure limits set forth for an
        uncontrolled environment. This equipment should be installed and operated with minimum
        distance 30 cm between the radiator and your body.

**Français**

Cet équipement est conforme aux limites d'exposition aux radiations FCC/IC CNR-102
        établies pour un environnement non contrôlé. Cet équipement doit être installé et utilisé
        avec une distance minimale de 30 cm entre le radiateur et votre corps.

Last Published: May 29, 2025

[Previous Topic
QTS110 LED status indicators](https://docs.qualcomm.com/bundle/publicresource/80-60631-1/topics/QTS110-LED-status-indicators.md)