# Getting started

Source: [https://docs.qualcomm.com/doc/80-70015-14/topic/get_started.html](https://docs.qualcomm.com/doc/80-70015-14/topic/get_started.html)

This information describes the prerequisites, such as setting up a Secure Socket Shell
            (SSH) connection and verifying and storing the Media Access Control (MAC) address,
            required to bring up WLAN functionality. Before you begin, see [Qualcomm Linux Build Guide](https://docs.qualcomm.com/bundle/publicresource/topics/80-70015-254/introduction.html) for common
            infrastructure setup and build workflows.

## Set up UART/SSH

Source: [https://docs.qualcomm.com/doc/80-70015-14/topic/get_started.html](https://docs.qualcomm.com/doc/80-70015-14/topic/get_started.html)

### About this task

To set up debug Universal Asynchronous Receiver/Transmitter (UART) and Wi-Fi, and to
                connect to SSH, see  [Use SSH](https://docs.qualcomm.com/bundle/publicresource/topics/80-70015-254/how_to.html#use-ssh).

Note: When using the Secure Copy Protocol (SCP) to transfer files
                to or from a device, a password prompt appears. Enter
                    oelinux123 in the password field.

## Set WLAN MAC address

Source: [https://docs.qualcomm.com/doc/80-70015-14/topic/get_started.html](https://docs.qualcomm.com/doc/80-70015-14/topic/get_started.html)

Consider the following points regarding the WLAN MAC address:

- By default, the factory writes the WLAN MAC address in the one-time
                        programmable (OTP) memory of the network card.

    You can modify the MAC address using the following commands, if required. In
                        these commands, replace `wlanX` with the interface index name
                        0 or 1. For example, `wlan0` or `wlan1`.

        ifconfig wlanX down
        ifconfig wlanX hw ether xx:xx:xx:xx:xx:xx
        ifconfig wlanX upCopy to clipboard
- The MAC address that you set persists until a reboot or the next power cycle and
                    takes precedence over the factory-set MAC address stored in OTP memory.

Last Published: Oct 14, 2024

[Previous Topic
Overview](https://docs.qualcomm.com/bundle/publicresource/80-70015-14/topics/introduction.md) [Next Topic
Features](https://docs.qualcomm.com/bundle/publicresource/80-70015-14/topics/wi_fi_features.md)