Copy to clipboard

# Thermal zone The thermal zone connects Tsens hardware information, temperature thresholds, and mitigation actions. The thermal framework creates node IDs for each thermal zone rule defined in the device tree. The following table lists the `sysfs` commands used to read and customize the thermal zone configurations: Note `` in the table represents thermal zone ID. Table : Description of thermal zone commands | Commands | Description | | --- | --- | | cat /sys/class/thermal/thermal_zone*
Copy to clipboard | Lists all thermal zones and their IDs that the device
contains | | echo enabled > /sys/class/thermal/thermal_zone/mode
Copy to clipboard | Enables a thermal zone

Note

All thermal zones are enabled by default. | | echo disabled > /sys/class/thermal/thermal_zone/mode
Copy to clipboard | Disables a thermal zone | | >
>
> echo >/sys/class/thermal/thermal_zone/trip_point__temp
> Copy to clipboard

Here,

`trip_temp` is the temperature threshold in m°C. `A`
denotes trip point numerical.
For example, you can modify the temperature threshold for a
trip point 0 using the following command:

>
>
> echo 95000 > /sys/class/thermal/thermal_zone20/trip_point_0_temp
> Copy to clipboard |

Modifies threshold temperature for trip point A

Verify the number of trip points available to the thermal
zone in the thermal zone directory:
/sys/class/thermal/thermal_zone<x>
and run the command

| | >
>
> echo > /sys/class/thermal/thermal_zone/trip_point__hyst
> Copy to clipboard

Here,

`trip_hyst` is hysteresis value in m°C. `A` denotes trip
point numerical.
For example, you can modify hysteresis for trip point 0,
which means a clear threshold is triggered at trip\_temp-1000
m°C using the following command:

>
>
> echo 1000 > /sys/class/thermal/thermal_zone20/trip_point_0_hyst
> Copy to clipboard |

Modifies hysteresis value for trip point A

Verify the number of trip points available to the
thermal zone in the thermal zone directory:
/sys/class/thermal/thermal_zone<x>

and run the command | Note Modifications to temperature threshold configurations should be for test purpose only. Do not change any thermal zone configurations of Tsens. Modifications performed through `sysfs` commands are changed to default values when the device is reset. You can add a product specific thermal zone and its rules in the device tree to control the temperature of the device according to the thermal requirement as described in: [Configure a new thermal zone](https://docs.qualcomm.com/doc/80-70017-30/topic/customize.html#section-lq4-xxb-51c). Last Published: Jan 26, 2025 [Previous Topic Interfaces](https://docs.qualcomm.com/bundle/publicresource/80-70017-30/topics/thermal-interfaces.md) [Next Topic Cooling devices](https://docs.qualcomm.com/bundle/publicresource/80-70017-30/topics/coolingdevices.md)