# Wi-Fi TCP Source: [https://docs.qualcomm.com/doc/80-58740-4/topic/wifi-tcp.html](https://docs.qualcomm.com/doc/80-58740-4/topic/wifi-tcp.html) This section mainly introduces the use of QCC743/QCC744 Wi-Fi and how to make TCP requests. ## Hardware preparation See [Hardware preparation](https://docs.qualcomm.com/doc/80-58740-4/topic/wifi-http.html#wifi-http__section_jgv_kxd_41c) ## Software implementation For more detailed code, refer to examples/wifi/sta/wifi\_tcp. ## Compile and program - The Makefile file has already configured CHIP and BOARD parameters, and does not need to be filled in by the user. $ cd examples/wifi/sta/wifi_tcp $ makeCopy to clipboard ## Experimental phenomena - Open the serial port terminal software, press the reset key, and output the log. Press the Enter key to display the words `qcc74x />`, similar to the Linux terminal. - Enter wifi\_sta\_connect ssid pwd to connect to the network, where ssid is the connected ap name and pwd is the connected ap password - After the Wi-Fi connection is successful, the assigned IP address will be printed out and CONNECTED will be prompted. If you want to test TCP Tx, use the following instructions for testing. - The TCP server must be initialized on the PC side of the same LAN using the iperf instruction - Enter wifi\_tcp\_test Server IP port to connect to the tcp server If you want to test TCP Rx, please use the following instructions for testing. - Enter wifi\_tcp\_echo\_test port to start a TCP server - The client can connect to the TCP server of the module through the iperf command **Parent Topic:** [Wi-Fi 6](https://docs.qualcomm.com/doc/80-58740-4/topic/wifi6_1.html) Last Published: Feb 10, 2025 [Previous Topic Wi-Fi HTTP](https://docs.qualcomm.com/bundle/publicresource/80-58740-4/topics/wifi-http.md) [Next Topic Wi-Fi UDP](https://docs.qualcomm.com/bundle/publicresource/80-58740-4/topics/wifi-udp.md)